Manual of uniform traffic control devices

The Manual of Uniform Traffic Control Devices (Queensland), within the meaning of the Transport Operations (Road Use Management) Act 1995, contains the design of, and the methods, standards and procedures in relation to every sign, signal, marking, light or device, installed on a road.

The 2003 edition (2009 issue) of the MUTCD is available at this site in read only format.

Manual of Uniform Traffic Control Devices (MUTCD)

Manual of Uniform Traffic Control Devices (MUTCD)

  1. Table of contents and index (PDF, 74 KB) 
  2. Issue notes (PDF, 174 KB) 
  3. Part 1: general introduction and sign illustrations (PDF, 1.62 MB) 
  4. Part 2: traffic control devices for general use (PDF, 1.87 MB) 
  5. Part 3: works on roads (PDF, 5.07 MB) 
  6. Part 4: speed controls (PDF, 0.87 MB) 
  7. Part 5: street name and community facility name signs (PDF, 420 KB) 
  8. Part 6: service and tourist signs (PDF, 1.56 MB) 
  9. Part 7: railway crossings (PDF, 1.35 KB) 
  10. Part 8: freeways (PDF, 0.43 MB) 
  11. Part 9: bicycle facilities (PDF, 1.18 MB) 
  12. Part 10: pedestrian control and protection (PDF, 0.36 MB) 
  13. Part 11: parking controls (PDF, 2.03 MB) 
  14. Part 12: bus, transit and truck lanes (PDF, 604 KB) 
  15. Part 13: local area traffic management (PDF, 1.04 MB) 
  16. Part 14: traffic signals (PDF, 561 KB) 
  17. Part 15: direction signs, information signs and route numbering (PDF, 1.91 MB)

Note: These documents (with the exception of part 3) are view only (print disabled) due to Standards Australia copyright provisions.

Purchase of this manual is from the Technical publications. Any enquiries about orders Ph: +61 7 3834 5488.

Last updated: 21 September 2009